|
 |
AIR INTAKE LOUVER
The Air Intake Louver is made of Fibreglass Reinforced Polyester(FRP) .
As the louvers are made of FRP, the life span is much long.
Also with the unique one piece design, removal for cleaning is easier. |
|
 |
CASING & BASIN
The Casing & Basin are made of fibreglass reinforced polyester (FRP).
This oblivates the need for painting repairs thus reduces the maintenance cost.
|
|
 |
3 IN 1 FILLER
Filler is vacuum-formed of 0.4mm thick PVC film with excellent chemical
and distortion resistance, and is suitable for operation with inlet
water temperature up to 55 o C . Its compact small package design is easy
to taking out for cleaning.
The special configuration of the filler incorporates the function of drift eliminator,
louver and wet-deck surface. The honeycomb shaped louver contributes minimum resistance
to airflow and prevent the ingress of foreign matters.
The drift eliminator feature prevents water droplets from escaping in the exhaust air stream
so as to ensure the drift loss to be less than 0.01% of circulating water flow rate.
The wet-deck surface are specially designed to provide maximum air/water contact and
low air pressure drop to ensure high efficient heat transfer.
|
|
 |
DISRIBUTION SYSTEM
Distribution System is specially designed. It distributes water evenly over the entire
top of in-fill ensuring maximum performance.
|
|
STEEL STRUCTURE
All supporting steel members are hot-dip galvanized to minimize rusting
and corrosion and ensuring long service life even in corrosive atmosphere.
The stainless steel hardware members are also available upon request.
|
|
 |
Motor & Fan
All Fan blades are of the adjustable pitch type and are manufactured from
polycarbonate material. Each fan is pre-set and balanced in factory
All Fan motors are TEFC Flange type with cast iron casing and stainless steel shaft.
|
|
|
